How to Connect Soundcore Earbuds to Android

Wireless headphones and earbuds have become an increasingly popular choice due to their convenience. Earlier, you just needed to connect the wire of an earphone to your device to listen to music, but with earbuds, the process can be a little different. You’ve come to the right place if you have gotten your hands on the infamous Soundcore earbuds and don’t know how to connect them to your Android device. Let’s jump right in!

How to Connect Soundcore Earbuds to Android

How to Connect Soundcore Earbuds to Android

Earbuds offer a level of flexibility that is hard to compete. Their Bluetooth tech makes it rather simple to quickly connect with your phone. Follow these methods to pair your Soundcore earbuds:

Option 1: For Soundcore General Earbuds

Your Soundcore earbuds first need to enter pairing mode in order to be connected to the Bluetooth of your Android phone. Follow these steps to do the same:

Note: Make sure your Bluetooth is enabled on your Android device first.

1. Take both the earbuds out of its charging case.

2. Long press both the buttons on the earbuds together until they start blinking a white light.

3. Release the button on the right earbud while continuing to hold the button on the left earbud.

4. Once the left earbuds start blinking white light again, release the button.

5. Now, open Settings, tap on Bluetooth, enable it, and then tap on the Scan option.

Tap on Bluetooth and then tap on the Scan option.

6. Tap on Soundcore Earbuds and select PAIR.

Option 2: For Soundcore Liberty 3 Pro

The newer versions of Soundcore earbuds starting from Liberty Pro 3 do not need the buds to be taken out of their charging charge and put back on. Simply follow these steps to see how:

1. Open the charging case with earbuds in it and long press the power button.

2. Let the earbuds blink white light for about 3-4 seconds and release the power button.

3. Turn on Bluetooth on your Android device and then tap on Scan.

4. Tap on Soundcore earbuds and select PAIR.

That’s it, your Soundcore earbuds will now successfully be paired to your Android device.

Why is My Soundcore Earbud Not Connecting?

There can be multiple reasons why your earbuds may not be connecting to your device:

  • Your earbuds are not in pairing mode.
  • Your Bluetooth is disabled.
  • The earbuds are low in battery.

You can try disconnecting and reconnecting your earbuds to check if they can connect to your phone.

Can You Pair Soundcore Earbuds to 2 Devices?

Yes, it is possible to connect your Soundcore earbuds simultaneously to two devices. However, you cannot listen from both devices together.

How Do I Reset My Soundcore Earbuds

If you wish to reset your Soundcore earbuds, follow the steps mentioned below:

Note: Make sure your earbuds are fully charged.

1. Put the earbuds in its charging case and press the power button for 10 seconds.

2. Release the power button after the earbuds have blinked white light 3 times.

Also Read: 15 Best Truly Wireless Earbuds Under 3000 in India

Now that you have understood how to connect your Soundcore earbuds to an Android device, make its use to its fullest. If you have any queries or suggestions, do not hesitate to reach out to us in the comment section. Keep visiting TechCult for more tech-related know-how.

Leave a Comment

Your email address will not be published. Required fields are marked *